Learn how to make this Devil Heart by Posummerny. Unlike normal origami hearts, this one has horns and a barbed tail! It fits under Origami Heart category and under Halloween Origami.
The original diagram is nicely hand-drawn; but, there are a few tricky steps which can be challenging. I decided to make a "help" page for these tricky sections. But, since I had the camera out and I was folding the model anyway, I decided just to take photos of every step. However, be sure to check out the original instructions to this clever and elegant design. The numbers under the photo corresponds to the numbers from the original diagrams so you can compare the steps.
1
2
The original diagram calls for a sheet of paper that is 10cm wide and 30 to 40 cm long.
I used 4 inches x 11 inches and it works fine. The tail is a little shorter.
This information is free freely available on the internet. If you have a model that you would like to share, or if you see your model here and would like it removed, please Contact Us. Diagrams are intended for personal use. Copyright of the models lie with the origami creators and designers. Please contact the designer and/or creator directly for non-private usage of a model and/or artwork.