Quilling - Combing - Spreuers

In basic quilling, you use a slotted quilling tool or a quilling needle.
In husking, you use round-headed pins.
In combing, you use an onion holder, also called a "quilling comb".

An onion holder looks like a hair pick - the kind used by people with Afro hairstyles. In the technique of combing in quilling, you can use a regular comb, a pick comb, or an onion holder - they all work equally well. Originally, an onion holder is used to hold an onion as you cut it. The metal tines (prongs) dig into the onion layers and allows you to chop the onion without endangering your fingers.

Shown from left to right are shapes you can make with combing:
                - leaf-like shape (called spreuer),
                - spreuer made with different color paper,
                - single-sided spreuer,
                - flower made with 5 spreuers,
                - flower made with 5 single-sided spreuer.
quilling spreuer


In quilling, a strip of paper is wrapped around the tines of the onion holder. There are at least 3 ways to use an onion holder:
      - make flat, leaf-like shapes
      - make evenly shaped petals
      - make exotic, filigree leaves
Let's start with making spreuers...

Making Spreuers: flat, leaf-like Shapes
This technique of combing is also called "spreuer" after the Swiss art of wrapping straw into flat, leaf-shapes. See an example of Swiss spreuers here. The term "straw" means "hay" or "dried grass", it does not refer to plastic drinking straws. quilling spreuer
  1. Start by getting an onion holder or a comb and a strip of paper. In this example, the quilling comb had 15 metal tines (prongs). The paper was 1/8" wide.
    Fold the tail end of the paper so it forms a hook.


    quilling spreuer
  1. Hook the paper onto the bottom tine so the hook is in front and the paper is behind the comb.
  2. Weave the long end of the paper to the front of the comb. In this example, the paper is weaved between tines 6 and 7. Add a drop of glue on the hook.
  3. Pull the long end of the paper down towards the hook. Press the two layers together and hold for a few seconds so the glue can set.

  4. quilling spreuer
  5. Bring the long end of the paper up behind the comb. Weave the paper to the front between the tines that are just one below. In this case, the paper passes between tines 5 and 6. The paper will be offset a little.
  6. Place a dab of blue near the base of the paper where the hook would have been.
  7. Pull the long end of the paper down towards the base. Press down for a few seconds so the layers glue together.

  8. quilling spreuer
  9. If you are making a double sided spreuer then repeat steps 5, 6, and 7 but on the left side:
  10. Pull paper up behind the tool, weave it between tines 5 and 6,
  11. add a drop of glue at the base, then
  12. bring the paper down and press until glue is set.

  13. quilling spreuer
  14. Continue in this manner: wrap the paper around the tines, alternate from right to left; move down one rung at each iteration.
    quilling spreuer
  1. When done, cut off excess paper and glue down the loose end.
  2. Slide the completed leaf-like shape (spreuer) off the tines.

quilling spreuer
Shown are (from left to right):
    - leaf-like shape (spreuer),
    - spreuer made with different color paper,
    - single-sided spreuer,
    - flower made with 5 spreuer,
    - flower made with 5 single-sided spreuer.
As you might imagine, these flat shapes can be used for many things including the wings of birds and butterflies.

quilling combing